I have an ASA 5585 in transparent mode, multi-context. It seems that the option to configure a BVI in one of the traffic contexts isn't there. In other words, while I see the option to configure a bridge group interface in the admin context, no such option comes up in the traffic context.
ciscoasa/admin(config)# interface ?
configure mode commands/options:
BVI Bridge-Group Virtual Interface
Management Prefix of interface Management0/0
ciscoasa/admin(config)#
ciscoasa/admin(config)# changeto context dmz
ciscoasa/dmz(config)#
ciscoasa/dmz(config)# interface ?
configure mode commands/options:
Port-channel Prefix of interface Port-channel30.411, 30.412, 30.413, 30.414
ciscoasa/dmz(config)#
I thought that maybe I need to first allocate BVI interface(s) in the system context (in order to seem them in the traffic context) but that doesn't seem to be an option either.
ciscoasa/dmz(config)# ch system
ciscoasa(config)# interface ?
configure mode commands/options:
GigabitEthernet GigabitEthernet IEEE 802.3z
Management Management interface
Port-channel Ethernet Channel of interfaces
Redundant Redundant Interface
TenGigabitEthernet Ten GigabitEthernet
<cr>
ciscoasa(config)#
Has anyone seen this or know what the issue is? Thanks.
