Can we use PBR in ASA version 8.2

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-05-2016 02:20 PM - edited 03-12-2019 01:14 AM
Hi ,
I got a cisco ASA 8.2 which has one LAN interface and two ISP. ISP1 and ISP 2.
ISP1- All outbound connections. There is a default global NAT for this. Default Route with lower metric is created to ISP1.
ISP2 - All Inbound connections. Static NAT are created.Default Route with lower metric is created to ISP2.
Now, i need the internal IP which are static NATed to IP address from ISP2 IP to use ISP 2 when they go outbound but since the default route is to ISP1 , it goes there.
I got to know that PBR can be used to send particular source IP to use ISP2 for outbound connections. But cannot find proper documentation to do it. Any views would be highly appreciated.
Regards
Vaibhav
- Labels:
-
NGFW Firewalls
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-05-2016 02:45 PM
You legacy ASA doesn't support PBR. You need an -X model for PBR-support.

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-06-2016 02:15 AM
Hi Karsten/Aditya,
Thanks for your reply.
Is there any other way I can do a source based routing?
Regards
Vaibhav

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-05-2016 04:57 PM
Hi Vaibhav,
8.2 ASA does not support PBR.
PBR support on ASA is post 9.4 code and that too on the ASA-X models:
http://www.cisco.com/c/en/us/td/docs/security/asa/asa94/config-guides/cli/general/asa-94-general-config/route-policy-based.pdf
Regards,
Aditya
Please rate helpful posts and mark correct answers.
