Cannot apply Access control policy to sensor
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-14-2016 01:50 PM - edited 03-12-2019 05:56 AM
I've a FirePower 7110 that could not take in access control policy from my Management center.
FirePower version - 5.4.0.4
Management center - 5.4.1.4
I'm getting this message when applying the policy from management center:
"Access Control Policy apply failed (Unable to retrieve running Intrusion Policy data from device)"
Anyone have any idea what's happening?
- Labels:
-
NGIPS
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-25-2016 05:16 AM
Hi,
As per the issue you are facing , could you try to disable intrusion policy in the access control policy
you are trying to deploy and then try to apply the policy again.
Thanks,
Ankita
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-06-2017 09:34 PM
Dear Friend,
what did you did when you face this above mentioned issue. i also faced the same issue regarding Instrusion policy failure while i applied access control list. but when i unregistered the Firepower module from Firesight management center and registered again. then problem will be solved and access control policy were applying successfully but its not a satisfactory resolution for me. any other reason why we faced this issue, and how could we resolve it.
Regards,
Mohammad Talha Omer
