Cannot deploy due to disk0:/anyconnpkgs/cisco-secure-client-win-5.1.8.

[jjevans1]

I cannot deploy due to Cisco Client file that is on the FTD. It was fine before and I could deploy no problem. Now that Snort has an update I need to deploy but cannot due to error:

The disk is (or was) full during extraction.

WARNING: Unable to install image

WARNING: Unable to remove image

Config Error -- anyconnect image disk0:/anyconnpkgs/cisco-secure-client-win-5.1.8.105-webdeploy

What can I do to either remote the file that is corrupt or get this box to deploy? I cannot update the FTD until this is resolved.

Any insight is appreciated.

Thank you, J

[jjevans1]

Disk space looks ok so not sure why deployment would fail?

> show disk
Filesystem Size Used Avail Use% Mounted on
rootfs 3.3G 6.4M 3.3G 1% /
devtmpfs 3.3G 5.5M 3.3G 1% /dev
tmpfs 3.9G 508K 3.9G 1% /run
/dev/sda1 7.2G 1.6G 5.3G 23% /mnt/boot
/dev/sda2 922M 192M 683M 22% /opt/cisco/config
/dev/sda3 922M 46M 830M 6% /opt/cisco/platform/logs
/dev/sda5 149G 33G 117G 22% /opt/cisco/csp
/dev/sda4 28G 148K 26G 1% /var/data/cores
cgroup_root 3.9G 0 3.9G 0% /dev/cgroups
none 127M 80M 48M 63% /dev/shm/snort
tmpfs 1.0M 0 1.0M 0% /var/data/cores/sysdebug/tftpd_logs

[jjevans1 · Accepted solution]

Cleaned out upgrade directory then rebooted system. Ran all updates then was able to finally clear deployment.