Good evening - I'm receiving the following error when trying to remove wccp and reconfigure it: ERROR: Can't change redirect-acl, first remove wccp configuration and re-enter with new redirect-acl. I was running version 9.8(1), and I ran across a very similar thread where upgrading to 9.8(2) resolved the issue. I have upgraded to version 9.8(2), but I still cannot fully remove my WCCP commands. Actually all I want to do is modify it to point to a new group-list, but I can't even do that. We after upgrading the software we did reload the firewall, but I'm still not able to remove/modify any wccp rules. We were using 90 to filter both 80 and 443; but we had to revert back to our older S360 when our S170 died. I'm afraid if I attempt to remove all WCCP configs and start from scratch, I won't have any traffic being inspected/filtered at all. Any suggestions? I'm going to open a TAC case in the morning, but any suggestions are greatly appreciated!
