09-14-2021 09:14 AM
Hi All,
I am having trouble registering a virtual FTD running on a 4415 chassis, to a physical FMC.
I have checked the logs and can see:
err 9:certificate is not yet valid
and the FTD's time is showing as:
> show time
UTC - Thu Apr 15 06:17:27 UTC 2010
Localtime - Thu Apr 15 02:17:27 EDT 2010
Even though the chassis itself has the correct time (I would have thought, when I create a cirtual device on the chassis, it would take the chasis's time??)
So I assume this is the problem Is there anyway I can manually set the time to current on the FTD, baring in mind it is virtual so I cannot locally manage it via a GUI.
TIA
Steve
Solved! Go to Solution.
09-14-2021 01:18 PM
I ran into a similar issue several months back. TAC advised to make sure the chassis was synced to NTP and timezone set to UTC. Once I did that, the FTD device and LINA subsystem had the correct time (inherited from the chassis as you surmised).
09-14-2021 09:40 AM
09-14-2021 09:41 AM
Can you verify the time in FXOS is correct and coming from the NTP server by running command
FPR4100-8-A# scope system
FPR4100-8-A /system # scope services
FPR4100-8-A /system/services # show ntp-server detail
Below is the guide which might be helpful in t-shooting this:
Regards,
Chakshu
Do rate helpful posts!
09-15-2021 03:21 AM
Thank you for the response. There was no output to the commands you specified as NTP was not configured.I configured this, deleted the original VM, rebooted the Chassis, recreated the VM, and it appears to have worked! The VM didn't take the new time even with NTP configured until after the chassis reboot, so not sure exaclty what part fixed the issue, but I suspect configure NTP and reboot chassis were the requried steps.
Thanks again for your help!
09-14-2021 01:18 PM
I ran into a similar issue several months back. TAC advised to make sure the chassis was synced to NTP and timezone set to UTC. Once I did that, the FTD device and LINA subsystem had the correct time (inherited from the chassis as you surmised).
09-15-2021 03:22 AM
Thanks so much for your response!
I configure NTP and reboot the chassis. Then when creating VM's the time is indeed taken correctly from the Chassis config.
Thank you very much for the help!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide