06-14-2006 11:53 AM - edited 02-21-2020 12:58 AM
Hello,
I recently set up an Active/Standby failover configuration with 2 sub-interfaces configured on my g0/0 interface (g0/0.1 and g0/0.2) for some reason I cant ping either of these from my testing server (when the server is on the correct network and subnet to test the interface)? I am not sure whats going on... I included a print out of most of my current configuration.
interface GigabitEthernet0/0
no nameif
security-level 0
no ip address
!
interface GigabitEthernet0/0.1
vlan 10
nameif Outside1
security-level 0
ip address 66.38.x.x 255.255.255.224 standby 66.38.x.x
!
interface GigabitEthernet0/0.2
vlan 20
nameif Outside2
security-level 0
ip address 64.187.x.x 255.255.255.224 standby 64.187.x.x
!
interface GigabitEthernet0/1
nameif DMZ
security-level 100
ip address 10.10.x.x 255.255.255.0 standby 10.10.x.x
!
interface GigabitEthernet0/2
nameif Private
security-level 40
ip address 192.168.x.x 255.255.255.0 standby 192.168.x.x
!
interface GigabitEthernet0/3
description LAN/STATE Failover Interface
!
interface Management0/0
description STATE Failover Interface
no nameif
security-level 100
ip address 192.168.x.x 255.255.255.0
!
clock timezone EST -5
clock summer-time EDT recurring
pager lines 24
logging enable
logging monitor debugging
logging asdm informational
mtu Outside1 1500
mtu Outside2 1500
mtu DMZ 1500
mtu Private 1500
failover
failover lan unit primary
failover lan interface FoInt GigabitEthernet0/3
failover replication http
failover link FoInt GigabitEthernet0/3
failover interface ip FoInt 192.168.x.x 255.255.255.0 standby 192.168.x.x
monitor-interface Outside1
monitor-interface Outside2
Thanks,
Chris
06-14-2006 09:56 PM
Anyone have a suggestion?
06-15-2006 09:16 AM
i would say your layer 2 config for the switch attached to this is not setup properly... does the asa have a trunk with a switch, so its speaking 802.1q?
Joe
06-15-2006 12:12 PM
Joe,
I am using a Dell 2624 switch for testing.... do I need to set another sub-interface to act as a trunk line for the g0/0 interface then? Also just wondering if that switch will work with Sub-Interfaces.... or do I have to re-think my setup?
Thanks,
Chris
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide