Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,Just set up 2 ASA 5520s in an Active/Passive configuration at our off site hosting facility in order to replace our old Pix firewall.We have an ISA2004 server at our office location which handles our traffic internally.VPN from our office to ou...
Hello,Just set up 2 ASA 5520s in an Active/Passive configuration at our off site hosting facility in order to replace our old Pix firewall. We have an ISA2004 server at our office location which handles our traffic internally.VPN from our office to o...
Hello,I just set up 2 ASA 5520s at my offsite location in an Active/Standby configuration. For some reason anytime that we RDP, use Explorer or SQL Enterprise Manager to connect to our offsite location via VPN the connection intermittantly freezes. ...
I was just wondering if anyone knew how I could set 1 specific port for managment and that is it?? I dont want anyone to be able to access the switch from anywhere except a specific port but I cant figure it out through the graphical set up interface...
Hello,I am currently attempting to configure 2 VLANs on my ASA5520 and allow them to communication with my Catalyst 500 switch. The ASA Setup is fairly simple (to start) its 2 Sub-ints on the g0/0 interface. The Switch IP is 66.38.173.xxx 255.255.255...
In my opinion, this link is best for the setup of Active/Active. Lots of nice diagrams and things to explain what is happening. The Active/Active setup is about half way down.Rate if this helps please.Good Luck,Chrishttp://book.itzero.com/read/cisco/...
I get a notification error on the Catalyst saying "Undersized frames detected from the connected device" (which is my ASA). This happens when I attempt to ping from the ASA to the switch. I have re-done some config and set port 2 (connected to my AS...
I know that Cisco suggests that you dont use the Managment interface for your failover interface... but thats another issue all together. If you use the montior-interface command on Managment it should provide you with some more information (not posi...
