About jbrunner007

jbrunner007 · 11-17-2007

how do we get the CCIE to appear by our name in the forums here when we post?thanks,Joe

jbrunner007 · 06-11-2007

Hello,I have the following configuredfr_hub#sh run int s0/0.201Building configuration...Current configuration : 124 bytes!interface Serial0/0.201 point-to-point ip address 202.2.2.1 255.255.255.252 frame-relay interface-dlci 201 IETF fr_hub#sh run ...

jbrunner007 · 02-06-2007

What do you think would cause this output?On a leaf switched connected to CORE1 andCORE2....6509-server-NY-02#sh mac-addr int g8/42Legend: * - primary entry age - seconds since last seen n/a - not available vlan mac address type...

jbrunner007 · 10-18-2006

I have a pix 515e with two default routes, learned via OSPF from two routers on the "outside" interface.Currently router#2 is being preferred way much more than router#1. There are many thousands of destinations for the traffic. These two routers are...

jbrunner007 · 05-20-2005

I am sending a letter to Cisco Systems today. I have received too many of these fake wics from their supposed "Gold Partners". These fake wics DO NOT WORK, or ONLY WORK for a short time ! ENOUGH! http://www.affirmedsystems.com/counterfeit.html

jbrunner007 · 07-31-2007

Tell your CSO to get his CCIE security... he should know this stuff...I can't believe "troublemakers" like this raise cain and the engineers have to come to a message board for answers... LOLMr. Belfort, Sir..."my name is the Plague"

jbrunner007 · 07-30-2007

two options come to mind;create the same anycast loopback address on both possible bgp peers of the third peer, put both in to the IGP, and let the igp determine the best path to each...or just fully mesh to the loopback address of the peers.Joe

jbrunner007 · 07-27-2007

to actually get the behavior where eigrp uses unicast, and not multicast you need theneighbor x.x.x.x under the eigrp process.If you do this the interface on which this neighbor can be found switches from using multicast to unicast.

jbrunner007 · 06-12-2007

Sundar, You are correct!after I cleared the EIGRP neighbor,BGP is preferred...fr_hub#sh ip routeCodes: C - connected, S - static, R - RIP, M - mobile, B - BGP D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area N1 - OSPF NSSA e...

jbrunner007 · 06-12-2007

Sundar, I have a lab, and here is what I found out... Eigrp is definitely preferred over the EBGP route, just as suspected by Narayan.I used the 9.9.9.0/24 to lab this up... as expected bgp thinks its best route is the route it redistributed from eig...

Member Since	‎05-20-2005 01:18 PM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	96
Total Helpful Votes Received	66

User Statistics

User Activity

posting with CCIE by your name at the top

OSPF advertising MASK configured on interface

HELP ! This is an URGENT mystery!

Pix OSPF load balancing question

Stop the Fake WICS !

Re: picking up unicast traffic from a sniffer, but im on a switc

Re: Using HSRP VIP address as BGP peer ?

Re: eigrp

Re: Strange problem with EIGRP and BGP

Re: Strange problem with EIGRP and BGP