Change the FMC Access Interface from Management to Data

[rezaalikhani]

Hi all;

According to Cisco's technical documentation, one of the steps to change the FMC access interface from management to data is executing the following command:

configure network {ipv4 | ipv6} manual ip_address netmask data-interfaces

My question is that, which IP address should I use for the "ip_address" field? The current IP address for management interface, the IP address of the interface that I enabled for FMC Access or something else?

Thanks

[Mohammed al Baqari]

Hi,

The command you posted will change the IP address of the FMC management
interface and make the data interface as the gateway instead of
separate gateway. So you can use the same management interface IP.

***** please remember to rate useful posts