cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
19039
Views
10
Helpful
18
Replies

Cisco ASA 5510 Error 15 file not found

paul dungey
Level 1
Level 1

Good afternoon,

My firewall will not load the image see the output below,

I've seen a few comments on here but not quite sure how to resolve the image.

Booting system, please wait...

CISCO SYSTEMS

Embedded BIOS Version 1.0(11)5 08/28/08 15:11:51.82

Low Memory: 631 KB

High Memory: 1024 MB

PCI Device Table.

Bus Dev Func VendID DevID Class              Irq

00  00  00   8086   2578  Host Bridge

00  01  00   8086   2579  PCI-to-PCI Bridge

00  03  00   8086   257B  PCI-to-PCI Bridge

00  1C  00   8086   25AE  PCI-to-PCI Bridge

00  1D  00   8086   25A9  Serial Bus         11

00  1D  01   8086   25AA  Serial Bus         10

00  1D  04   8086   25AB  System

00  1D  05   8086   25AC  IRQ Controller

00  1D  07   8086   25AD  Serial Bus         9

00  1E  00   8086   244E  PCI-to-PCI Bridge

00  1F  00   8086   25A1  ISA Bridge

00  1F  02   8086   25A3  IDE Controller     11

00  1F  03   8086   25A4  Serial Bus         5

00  1F  05   8086   25A6  Audio              5

02  01  00   8086   1075  Ethernet           11

03  01  00   177D   0003  Encrypt/Decrypt    9

03  02  00   8086   1079  Ethernet           9

03  02  01   8086   1079  Ethernet           9

03  03  00   8086   1079  Ethernet           9

03  03  01   8086   1079  Ethernet           9

04  02  00   8086   1209  Ethernet           11

04  03  00   8086   1209  Ethernet           5

Evaluating BIOS Options ...

Launch BIOS Extension to setup ROMMON

Cisco Systems ROMMON Version (1.0(11)5) #0: Thu Aug 28 15:23:50 PDT 2008

Platform ASA5510

Use BREAK or ESC to interrupt boot.

Use SPACE to begin boot immediately.

Launching BootLoader...

Default configuration file contains 1 entry.

Searching / for images to boot.

No images in /

Error 15: File not found

unable to boot an image

Default configuration file contains 1 entry.

Searching / for images to boot.

No images in /

Error 15: File not found

unable to boot an image

Failsafe booting engaged.

Default configuration file contains 1 entry.

Searching / for images to boot.

No images in /

Error 15: File not found

unable to boot an image

ÿ

Booting system, please wait...

regards

Paul

18 Replies 18

Hi Jouni,

Followed you instructions, where i have the "Address or name of remote host" i just pressed enter

ciscoasa# copy tftp://192.168.1.1/asa725-k8.bin flash:/

Address or name of remote host [192.168.1.1]?

Source filename [asa725-k8.bin]?

Destination filename [asa725-k8.bin]?

Accessing tftp://192.168.1.1/asa725-k8.bin...

%Error opening tftp://192.168.1.1/asa725-k8.bin (No such device)

ciscoasa#

paul

Hi,

What is the output of the command

"dir flash:"

- Jouni

Hi Jouni,

run the Dir flash:

Directory of Disk0:/

No files in directory

regards

Paul

I had the same problem with ASA 5505, I opened the device and pushed the memory card, because it was not installed correctly. Best regards.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: