11-04-2010 12:53 AM - edited 03-11-2019 12:04 PM
Hello,
I have a ASA 5510 and I want to provide a rule for exchange ,
All user want to access to internet
I want to create a rule while I provide a object and in object ip address bloked by asa,
Because users use its ip address at same time.
can you help me please. whan I can I do,
11-04-2010 01:11 AM
For mail, you need to remove the following static NAT statement as it is incorrect:
static (outside,inside) mailsrv mail netmask 255.255.255.255
After removing the above, please "clear xlate".
Can you please advise what is actually not working? Inbound mail not working? Outbound mail not working?
11-04-2010 02:54 AM
Hi Jennifer,
when ı remove the this line what will I do?
static (outside,inside) mailsrv mail netmask 255.255.255.255
can you provide correct config line for me please.?
Thank You,
11-04-2010 03:41 AM
You already have the correct static NAT statement configured:
static (inside,outside) mail mailsrv netmask 255.255.255.255
So there is no other line that needs to be configured except removing the static NAT advised earlier.
11-04-2010 05:11 AM
Thanks,
Excuse me, I could not understand
I must remove this line, Are you sure ?
static (outside,inside) mailsrv mail netmask 255.255.255.255
is this line enough NAT rule for e-mail traffic outside and inside ?
11-04-2010 03:37 PM
Yes, this line: static (inside,outside) mail mailsrv netmask 255.255.255.255
is enough because that line works bidirectionally, ie: both for outbound and inbound.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide