03-14-2016 02:14 PM - edited 03-12-2019 12:29 AM
I have an HP 5406 r zl2 switch and Cisco ASA 5525-x device. Is it necessary to define an IP or vlan in transparent mode on this devices?Or is it needed to make a specific configuration?I just could define inside and outside interfaces. isnt it sufficient
03-14-2016 02:32 PM
Hi there-
You need IP addresses for management purposes. Please check out the ASA configuration guide below and let us know if you have any questions:
Thank you for rating helpful posts!
03-15-2016 04:47 AM
03-14-2016 11:04 PM
All bridge groups needs to have an IP configured.
--
Please remember to select a correct answer and rate helpful posts
03-15-2016 05:05 AM
so long as the 92.45.63.1/29 is in the same subnet as that which is on the inside and outside of the ASA then that is all you need for the BVI part.
--
Please remember to select a correct answer and rate helpful posts
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide