cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1382
Views
0
Helpful
3
Replies

Cisco ASA - add route

Timohamoto
Level 1
Level 1

Hi guys! I using GNS3 simulator with that kind of image of ASA.

I have two questions:

1) Why when I added static route it's does't show up in routing table?

2) Does it possible to configure with that image site-to-site ikev1/IPsec VPN for Lab's purposes?

Please take a look to screenshots

 

Screen Shot 2018-10-11 at 17.56.47.pngScreen Shot 2018-10-11 at 17.59.55.png

Also when I did remove "1 track 7" it started to ping

but I did't configure anything where were "track 7" used...

s.png

1 Accepted Solution

Accepted Solutions

balaji.bandi
Hall of Fame
Hall of Fame

Do you have any IP sla configuration in your config? check or post full configuration.

 

Site to site vpn is possible, if it demo you have limited throughput available for test.

 

but for testing concept it is ok.

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

View solution in original post

3 Replies 3

balaji.bandi
Hall of Fame
Hall of Fame

Do you have any IP sla configuration in your config? check or post full configuration.

 

Site to site vpn is possible, if it demo you have limited throughput available for test.

 

but for testing concept it is ok.

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

Marvin Rhoads
Hall of Fame
Hall of Fame

The interface must be up for a route to be installed in the routing table.

 

Also since you were tracking against a non-existent ip sla operation that would also prevent the route from being installed.

Ok! IP SLA not exist -it's explains! Thanks a lot!
Review Cisco Networking for a $25 gift card