Hello all, currently I'm troulbeshooting the following Topology: image 1 scenario: - All interface have access-list allowing the communication to every other IP range. - All the routes are known for each node. - The security-level of each interf...
Forum Posts
Hello,i got ( free of charge ) my hands on cisco 887VAW whit advipserviceslicense installed permanentnow i setup the router for home use but i have a problem,how to port forward?i need to port forward port 50500 to lan host 10.0.1.100 im new to cisc...
We have configured in an Active/standby array of ASAs a route tracking service to some destinations, each destination has a main and a secondary link.Tracking service is not the issue, we found in our syslog server events from our active unit saying...
Hii tried to create this lab that found on CISCO website below to confirm using windows 7 / VPN with ASA , but when i completed all steps i have this problem , any idea ?? this steps : https://www.cisco.com/c/en/us/support/docs/security/adaptive-secu...
Hi, i have a cisco ASA 5516 and need to be able to have 2 internal subnet communicate with each other connected to 2 different interfaces GigabitEthernet 1/1 is the outside connectionGigabitEthernet 1/2 is the DMZ connectionGigabitEthernet 1/3 in th...
I have a Cisco ASA 5510. I created a new VLAN and when I VPN in and try to either RPD, PING this VLAN I can;t. I believe I see the issue but not sure how to fix it. When in the ADSM Configuration - Objects - Network Objects I see something that sa...
Firepower device manger on the box of the 4110 with FTD image can manage all the features of the firewall include firepower service ((IPS ,URL ,AMP)?
Hello,Sometimes (once a month) occurs issues related to tunnel between Cisco router (our side) and Adaptive Security Appliance (other company).Problem disappears if tunnel is initiated from Adaptive Security Appliance side.How to fix this problem?
Resolved! logging device-id ipaddress
Hi everyone,If we config ASA with command belowlogging host inside 192.168.1.50Above command will send all log messages to server 192.168.1.50 right?If we also config command belowlogging device-id ipaddress inside What does above command do?will it ...
Hi,I'm just playing around with a few ASA's and wondering what allows return HTTP traffic into the firewall? Also, what other traffic is allowed by default like HTTP?Traffic is originating from a higher security interface (inside, 100) to a lower sec...
I am interested in getting all of my Cisco routers and Switches (with IOS <= 12.2) to use Azure MFA for SSH login. I do not want to use ASA or ISE or anything else like that. I would like to just authenticate them against a RADIUS or TACACS+ server, ...
Resolved! meraki mx64w reboot randomly
hi there I have this Meraki MX65W, per description from our client: Meraki MX65W serial number xxx-xxx-xxxx since we have had some problems with the equipment; I'll tell you briefly. 1. We tested the equipment in the Regional of YYYYYYYYY, the same...
Hello,Is Anti-replay (replay resistance) on by default, or is this something that you have to activate?
Just looknig for some advise in regards to keeping ACLs, objects, etc. clean and manageable. I know in a large prod environmnet, constantly adding IPs to block, adding rules, etc. can lead to a messy harder to understand ASA with rules on top of each...
Hi, we have a customer has two FP9300 chassis with two FTD security module per chassis. the customer asked for a cluster deployment the question is can we have intra chassis cluster for each chassis using the two security module per chassis and hav...
