cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1533
Views
0
Helpful
1
Replies

Cisco ASA SHA2 Support

William Parsley
Beginner
Beginner

Is it possible to use the SHA2 signature algorithm when generating a self-signed certificate on an ASA? I can't seem to find any documentation showing commands that have control of things like the signature algorithm when using self-signed certificates. I've seen documentation that SHA2 is supported as of 8.4.2 for the signature algorithm, but it always refers to importing a certificate from some external CA.

1 Accepted Solution

Accepted Solutions

Dinesh Moudgil
Cisco Employee
Cisco Employee

<Duplicate post.>

Please follow this post: https://supportforums.cisco.com/discussion/12700106/asa-sha2-support-self-signed-certificates#comment-10917826

R
egards,
Dinesh Moudgil

P.S. Please rate helpful posts.

Cisco Network Security Channel - https://www.youtube.com/c/CiscoNetSec/

View solution in original post

1 Reply 1

Dinesh Moudgil
Cisco Employee
Cisco Employee

<Duplicate post.>

Please follow this post: https://supportforums.cisco.com/discussion/12700106/asa-sha2-support-self-signed-certificates#comment-10917826

R
egards,
Dinesh Moudgil

P.S. Please rate helpful posts.

Cisco Network Security Channel - https://www.youtube.com/c/CiscoNetSec/
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers