Cisco ASA SLA RTT OID

[Kevindran Pillay]

Hi There,

I have got an SLA setup on a Cisco ASA 5520 running ver 8.2(1),

I a looking to monitor the "Latest RTT" stats, I am struggling to find the actual OID for this, is it possible?

Entry number: 126020190
Modification time: 09:47:09.109 UTC Sun Aug 16 2015
Number of Octets Used by this Entry: 1480
Number of operations attempted: 54
Number of operations skipped: 0
Current seconds left in Life: Forever
Operational state of entry: Active
Last time this entry was reset: Never
Connection loss occurred: FALSE
Timeout occurred: FALSE
Over thresholds occurred: FALSE
Latest RTT (milliseconds): 30
Latest operation start time: 12:26:09.112 UTC Sun Aug 16 2015
Latest operation return code: OK
RTT Values:
RTTAvg: 30      RTTMin: 30      RTTMax: 30
NumOfRTT: 3     RTTSum: 90      RTTSum2: 2700

Thanks,

Kevin

[m.kafka]

Hi Kevin,

a good starting point to further drill down is:

http://tools.cisco.com/Support/SNMP/do/BrowseOID.do?local=en&translate=Translate&objectInput=1.3.6.1.4.1.9.9.42#oidContent

Especially this (rttMonLatestRttOperCompletionTime):

http://tools.cisco.com/Support/SNMP/do/BrowseOID.do?local=en&translate=Translate&objectInput=1.3.6.1.4.1.9.9.42.1.2.10.1.1#oidContent

and this (rttMonLatestRttOperSense):

http://tools.cisco.com/Support/SNMP/do/BrowseOID.do?local=en&translate=Translate&objectInput=1.3.6.1.4.1.9.9.42.1.2.10.1.2#oidContent

Rgds, MiKa

[Kevindran Pillay]

Thanks MiKa,

I did try previously to query those OID's on the ASA but no result. I am not sure whether there are any OID's specifically for the ASA for SLA monitoring.

Regards,

Kevin

[m.kafka]

Hi Kevindran,

I was a little bit hasty with my comment. Unfortunately ASA doesn't support the Cisco rttMon MIB.

Sorry and best regards, MiKa

[cjvermeulen1]

Unless they added OIDs for this in the newer releases, I don't think their was ever an OID to monitor SLA's/Trackers on an ASA. I believe an SLA or Tracker creates a specific log event when it changes, so you could use EEM or a logging rule to generate an SNMP or syslog alert.

[Kevindran Pillay]

Thanks, I think that is probably the way I would have to go.

Regards,

Kevin