Network Security

Hi ! We are using our ACS server 5.6 running patch Level 4 to authenticate users on different telecom equipment  with in the Compagny. I'm actually trying to configure "read only access" for some users to our BlueCoat Packet Shapper device.  The fu...

Hello, I have installed Cisco Router that is connected to dual German ISPs and ASA 5508-X. The network is as follows: ----------------------------------------------------------- ISP1                           ISP2 192.168.1.1              192.168.2.1...

Hi everybody, I want to know if the Catalyst 4507 (2 Switchs as a VSS) is compatible with ASA 5585-X Spanned Etherchannel Clustering? I didn't see it in the external hardware and software support for asa cluster. Did anyone tested this?  Regards.

Hello All, Thanks for taking the time to read. I've been searching through the community but still a little confused as to the Control license.  I received a slip of paper with the 5506 and dutifully went to licensing and redeemed the PAK.  All seeme...

Hi Guys, When you do show nat or show run access-list it is a nightmare to trace objects and object groups. Is there a way to see the resolved object when running show nat ? or show an object group? with acl, I do show access-list x rather than sh...

Hi All,What does sizing throughput means ?Sizing Throughput [440 byte HTTP2]:Application Control (AVC) or IPS 1taken fromhttp://www.cisco.com/c/en/us/products/collateral/security/asa-5500-series-next-generation-firewalls/datasheet-c78-733916.html

Hi, we have a block of 8 ip's and a DMZ setup on an ASA 5510. We're using static NAT to forward ports onto hosts in the DMZ but I was wondering if it was possible to assign one of these hosts one of the public ip's directly rather than use a private ...

All of a sudden today I can no longer access ASDM and SSH on my firewall.Console login and even telnet work fine.This is not a permissions problemhttp server enable is thereand appropriate HTTP and SSH permissions are in placeIt has literally just ha...

We have an ACE module on 6513 where in the rservers are hosted behind the ACE in routed mode.  We are having an issue where in we lost connectivity to all servers behind the ACE from outside world.  From the servers they were able to reach their gate...

Hello, I work for a company located in Luanda-Angola, during the hollidays we had a power surge that damaged two of our Cisco Swithces. On our Catalist 2960 48 ports PoE ,4 ports got completely burned ,on our Catalist 2960 48 ports PoE ,2 ports got b...

Hi all, I have a problem with the following setup. We have multiple offices connected via VPN to the HQ, because two offices sharing a lot of data, we want add to the ASA 5505 firewalls a second VPN site-to-site tunnel to transport the traffic direc...