Hi All,
we have cisco asa 8.2(5), observed that snmp server is not getting the reply from the standby firewall sometimes for a fraction of seconds and some times it lasts for 5-6 mins, and automatically it comes up. Snmp server is getting connected to Inside interface of the firewalls through cisco switches.
Below is the snmp & failover cfg. Can some one help ??
failover
failover lan unit secondary
failover lan interface faillink GigabitEthernet3/3
failover polltime unit 2 holdtime 6
failover replication http
failover link faillink GigabitEthernet3/3
failover interface ip faillink 10.1.2.1 255.255.255.252 standby 10.1.2.2
snmp-server host inside 10.x.x.x poll community ****** version 2c
snmp-server host inside 10.y.y.y.y poll community ****** version 2c
snmp-server location 1st Floor ABCDE
snmp-server contact Vendor
snmp-server community *****
snmp-server enable traps snmp authentication linkup linkdown coldstart
snmp-server enable traps syslog
snmp-server enable traps entity config-change fru-insert fru-remove