09-27-2019 09:30 AM - edited 02-21-2020 09:32 AM
I have 2 ASA in Active/Standby Mode. On the secondary mode when i run a show version command its giving the following message :
The flash device is in use by another task.
How can i resolve this ?
Thanks
Solved! Go to Solution.
09-28-2019 02:24 PM
I suggest to reload the standby and try again and let us know. ( make sure you do this in maintenance window).
09-27-2019 11:43 AM
Most of the time always suggest using for Primary Active ASA for performing all tasks. and change configs
If you like to check below suggest methods :
check any active sessions :
show ssh sessions ( delete any ssh session active , other than yours)
If you are using asdm try
show asdm session
asdm disconnect - select session to disconnect and try
09-28-2019 01:26 PM
09-28-2019 02:24 PM
I suggest to reload the standby and try again and let us know. ( make sure you do this in maintenance window).
09-11-2020 09:34 AM
Did a reboot resolve the issue?
09-17-2020 07:42 AM
Yes a reboot resolved this
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide