Cisco Firepower 1120 firewall logging and Netflow config

[jonathan-mbewe]

We would like to configure logging and NetFlow on our Cisco Firepower 1120 Threat Defense firewall. However, we are unable to locate the NetFlow configuration options in both the Firepower Device Manager (FDM) Web UI and CLI interfaces.

The firewall is currently running software version 7.0.1-84.

Could you please assist us with the steps or guidance on how to configure NetFlow on this model?

[Rob Ingram · Accepted solution]

@jonathan-mbewe you need to use FlexConfig to configure netflow when using FDM. Flexconfig allows you to manually configure ASA-style commands on an FTD device that are not yet supported through theGUI.

Guide - https://community.cisco.com/t5/security-knowledge-base/how-to-enable-netflow-on-firepower-using-fdm/ta-p/4048081