Cisco Firepower 2130 2140 2130 CLI config save
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-23-2023 04:17 AM
Hi All,
I have few pairs of the NGFW and have recently change the passwords on them via the "configure user password admin" command..
does anyone how to save the config/changes via CLI... or is auto saved?
models are 2140 2130 2120 running 7.0.4
Thank you
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-23-2023 05:20 AM
The allowed "configure..." commands entered on an FTD cli are all saved as soon as they are accepted by the device.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-24-2023 02:42 AM
there is no save command when configuring via the CLI. Management configuration is "automatically" saved, if you want to use that type of terminology.
Please remember to select a correct answer and rate helpful posts
