11-30-2023 08:30 PM
Hi guys,
I have a query regarding CISCO FMC Access Control Rules.
I use my Radius Account to login to FMC and also my colleagues. I have done some changes in the past but I already commited that changes I made before.
Now, I need to do another change on the ACL's but the thing is, everytime i click on any ACL we have, and then just press exit, I always got the message that popping out that there is an unsave changes and asking me if I am sure to exit without saving.
I dont remember doing anything in FMC recently. I also checked the Deployment and did not find any pending task that is under my username.
I also asks my colleagues if its happening as well on their side but its not, it only happens to my account.
Any thoughts?
Thanks,
Lem
11-30-2023 09:56 PM
12-04-2023 05:56 AM
It is normal behavior of FMC that closing an open ACP entry will give that prompt. I see it on all FMCs no matter what version.
12-06-2023 03:44 PM
Hi Marvin,
Thanks for your reply. Is this a bug? How come it only happens to my account?
And if you say that it's normal, i dont think it's good to have this issue. Like me I am not too familiar with Cisco FMC so if i see this kind of message then I can't do any changes as I will be a little conscious of what unsaved changes was that.
12-07-2023 05:38 AM
I don't know what your colleagues see for sure. For me, I always see the message if I go into edit mode of an ACP entry and then cancel out of that mode.
12-07-2023 05:58 AM
Perhaps asking this question in the FMC forum will be best to answer these questions.
https://community.cisco.com/t5/network-security/bd-p/discussions-network-security
12-07-2023 05:56 AM
From link I share
I've solved the issue by replacing all the 'Private Network' objects with 'IPv4-Private-All-RFC1918'.
MHM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide