Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi guys,I have a query regarding CISCO FMC Access Control Rules.I use my Radius Account to login to FMC and also my colleagues. I have done some changes in the past but I already commited that changes I made before.Now, I need to do another change on...
Hi experts, One of our router has an eHWIC card installed with an active cellular interface. This was designed to be the backup link whenever something goes wrong with our primary connection. I wanted to know if this has been setup the way it should ...
Hi experts, We have a 3 x 3850 stacked switch in the production.I have found out that it is not in a full ring stack, there is no stack cable connected on switch 1 and switch 3. Now, I need to connect a cable to it, I wanted to be 100% sure that this...
Hi Marvin,Thanks for your reply. Is this a bug? How come it only happens to my account?And if you say that it's normal, i dont think it's good to have this issue. Like me I am not too familiar with Cisco FMC so if i see this kind of message then I ca...
Hi, Would you guys be able to help me? I got almost same ios file that I tried to update and also the same I use the command "boot system" instead of boot system flash command.Now my issue is after issuing the command and reload the old ios file did ...
Hi Experts, Above is the output of stack-ports summary. All switches are working fine all ports are up from the 3 switches. The only issue here is that it is not working as a "full ring" as there is no stack cable connected to switch 1 and switch 3....
Hi Leo, I know what I need to do but I am just not 100% sure what would be the outcome if i just connect the stack cable from switch 1 port 2 to switch 4 port 1. As i said, the 3 stacked switch are running fine, it's just not in full ring stack. Addi...
