02-05-2018 08:49 PM - edited 02-21-2020 07:17 AM
Could you help me check oid of cpu and memory as the cli command below ?
> show cpu usage
CPU utilization for 5 seconds = 8%; 1 minute: 9%; 5 minutes: 9%
>
> show memory
Free memory: 46568759296 bytes (62%)
Used memory: 29531140096 bytes (38%)
------------- ------------------
Total memory: 76099899392 bytes (100%)
I used snmp walk like this threat: https://supportforums.cisco.com/t5/%E3%82%BB%E3%82%AD%E3%83%A5%E3%83%AA%E3%83%86%E3%82%A3-%E3%83%89%E3%82%AD%E3%83%A5%E3%83%A1%E3%83%B3%E3%83%88/firepower-system-snmp%E7%9B%A3%E8%A6%96%E6%99%82%E3%81%AEoid%E4%BE%8B-cpu-memory-etc/ta-p/3165792
But something went wrong, there is differrent result from cli command and snmp walk
thank you!
02-15-2018 08:51 AM
CPU MIB
1.3.6.1.4.1.9.9.109.1.1.1.1.3. cpmCPUTotal5sec 1.3.6.1.4.1.9.9.109.1.1.1.1.4. cpmCPUTotal1min 1.3.6.1.4.1.9.9.109.1.1.1.1.5. cpmCPUTotal5min
Memory MIB
1.3.6.1.4.1.9.9.48.1.1.1.5. ciscoMemoryPoolUsed 1.3.6.1.4.1.9.9.48.1.1.1.6. ciscoMemoryPoolFree
... keep in mind that this is only the lina part of FTD. As you may know FTD consists of two parts. Lina, which is basically the ASA code running in userspace and snort. Using the listed MIBs you will get stats for lina but not the various snort instances which handle L7 traffic.
As far as I am aware of there is no way to poll the linux part to get stats for snort instances using SNMP.
Hope that helps
02-02-2024 01:38 AM
1.3.6.1.4.1.9.9.48.1.1.1.5. ciscoMemoryPoolUsed 1.3.6.1.4.1.9.9.48.1.1.1.6. ciscoMemoryPoolFree
i am using this OIDs but all of my FTDs have no memory usage data in our monitoring tool. CPU usage is okay though.
10-08-2021 07:04 AM
Hi duyennv10;
The link below shows FTD's snmp OIDs:
I have just configured CPU 5 minutes OID (.1.3.6.1.4.1.9.9.109.1.1.1.1.8.1) on my CACTI server and it is working fine.
Regards.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide