Hello,I've successfully configured an external syslog server on FDM, and it's receiving messages correctly. I've set the Default Action Block to send syslog messages, and those are arriving as expected on the external server (among other messages).Ho...
Hello. I'm trying to update a firewall running FTD, managed via FDM, from version 7.0.1-84 to version 7.4.2-172. I uploaded "Cisco_FTD_SSP_FP1K_Upgrade-7.4.2-172.sh.REL.tar" on the System Upgrade section on the Updates page of FDM. When I click Up...
I’m experiencing latency issues with my internet service. I've identified that the setting "Intrusion Policy used before Access Control rule is determined" is enabled under the Advanced Settings of my APCs. My firewall is currently handling around 18...
I'm in a situation where I need to use the FTD as the dhcp server for both my guest and internal subnet. At present I have it configured to give out my internal domain and dns servers. Can I use a FlexConfig configuration to modify the dns settings...
Dear Team, We have both FTD 1120 Firewall. Between them HA peer configured. But for some reason we re image the standby firewall. Break the HA on primary firewall for rejoining standby firewall on HA.But after deploy HA on standby device HA Peer fail...
Greetings all. I have this little network I am working on and I have just came across an issue. The command I am trying to implement is"event manager applet BACKUP_CONFIG" . However, my issue stems from the fact that my other switches have taken this...
HIWhat is the easiest method to migrate FTD policies from one FMC then apply those policies to another FTD on the new FMC pleaselooks like I have to create routes, VPNs manually is this correct,? Thanks
HI Team - I am unable to find any link to check the EOS and EOL for cisco firepower 1120. Kindly assist me with same.
I tried in the FTD CLI and also in "system support diag" and can't seem to find duplex status. Where did they move this too? FTD is v7.4.2.2Thanks
I am trying to get this working to no avail. Whether I exclude the domain I want to resolve locally or include the domain I want to resolve through the tunnel the client sends all requests through the tunnel. I am specifying a DNS server on the gro...
Hi,I have two Firepower 2100 series devices clustered and managed by FMC version 7.4.2. Previously, when I was using FMC 7.2, I had configured time ranges on some rules, and they were working correctly. However, after upgrading to version 7.4, the ti...
Hi!FMC2500 is going to be EoL soon so we've decided to migrate to FMCv instead, since we already have all the hardware we need inour VMware datacenters.Current setup:2 x FMC2500 (in HA mode) v7.0.4(55).New setup, migration to virtual machines in VMwa...
This is an old question for an old firewall, but I've not found any definitive answer.I have found PLENTY of answers regarding the allowance of traceroute *through* a firewall.That is NOT what I'm asking.I need the firewall itself to perform the trac...
I have a handful of FP 1010s that came with FTD installed. These will be used for a basic S2S VPN connection back to a FP3130. I'd like to manage these via FMC but I'm struggling with the documentation to understand a clear path to getting this acc...
I have an HA pair of FMC's running v7.6.1.My Standby device is showing an alert "Process Status - the data correlator process exited x time(s)", additionally the Health Monitor is showing "SFDataCorrelator Down" and running pmtool status | egrep -i '...
