Cisco NAC < Checks using application´s hash value >

[j.muozmellado]

Hi Guys:

Is there any other way to configure the checks using the hash value of an application instead of register key ???  I have read and confirmed that the hash value does not change never. Its the same value....But I did not find a way to configure the rule on the CAM.... any idea ??  Thanks a lot. By the way I am using Cisco NAC 4.8.2

[j.muozmellado]

Guys, is this application´s hash value inside of a windows register key that I could take a look ???  Thanks Guys