Hi friends. I'm sorry if this is basic, but the Pix world is something I'm not very confident with.The attached configuration is of a Cisco Pix that was used at a remote office. It contains:
Inside traffic 172.16.0.0
Inside Nats to: 10.54.14.0
VPN tunnel forms with: 2.2.2.2
I want to reconfigure the LAN side of it so it's a flat network with no NAT. The VPN configuration should stay exactly the same. So I'm looking to reconfigure it as follows:
Inside IP: 10.39.16.1
No NAT translation
Could someone help me out with the Access Lists for this as I was getting confused as to what I need and what I don't.
Thanks in advance, help would be much appreciated.
Cheers