CiscoWorks-Device Fault Manager

[dborries]

I would like to install the HP-OV-Adapter from the Device Fault Manager but then the CPU-Utilisation goes up to 100% and stays there. What do I do wrong? Is there a workaround for it? I usr HP OV 6.20 on Solaris 7/SPARC. Thanx for help.

[blamb]

We are preparing to install the same software. You should check the server setup requirements for the Device Fault Manager. We found that it requires more RAM and Processor speed than previous versions. You may have to beef up your server.

[dborries]

The System requirements are ok. I have a Sparc Ultra 10 with 1024 MB RAM and 2048 MB SWAP-Space. available drivespace is although ok.

[rmushtaq]

Is there any specific process in DFM that is taking up 100% CPU ?. Output of top command should show you this.