Network Security

Dear All,I have PIX 506E and I want to backup pix images (.bin) to a safe locaation as per overall backup procedures.Please advise exact command to use.Thanks in advance

Can anyone tell me how to tell if I have a restricted or unrestricted liscense on my PIX-515? Here is the show ver.Firewall# sh ver Cisco Secure PIX Firewall Version 5.3(2) Compiled on Tue 03-Jul-01 21:57 by morlee Firewall up 9 mins 0 secsHardware: ...

I am currently trying to find out whether or not a static command would be needed to connect to an inside device from the outside w/o any NATs and assuming routing is in place for all. I have always been under the impression that statics were needed ...

The VPN works ok normally but when there is a power outage at remote site and after power/communication reusmes, we can ping router on remote site but not server which sends traffic though VPN to HO.Once the server from the remote side send pings to ...

Hi,How can i configure a remote client that can access my pix using telnet? i already issue the command telnet 192.168.1.1 255.255.255.255 insidetelnet timeout 5ssh timeout 5terminal width 80but when asking for the password, i cant get into the pix c...

Hi,I do have some trouble to get my dmz settings working. I have a reverse proxy, located in the dmz, which is supposed to redirect all http traffice to a certain domain to web server that is in the inside network. The PIX does NAT all connections or...

Hi,How I can connect remotly to PIX by SSH protocol, I mean what is the commands I should put it on PIX, and what is the setting for client SSH software(what is the prfered one,from where i can get it).Thanks for help

My network setup consists of a PIX firewall connected to a switched network with the PIX in turn connected to an Internet router. The PIX is used to for both web browsing and for termination of a handful of VPN tunnels with IOS routers on the other e...

I have been looking at using QoS to cut down on user web browsing traffic and downloading by assigning bandwidth and queue priority guarantees to more important traffic and therefore "starving" the bad traffic of bandwidth. However, it seems that mos...

I need to set up a P-2-P tunnel between a business client and my company. We attempted this today, we got past phase 2 but could not pass traffic. Here is they way I need to have it configured.3005 A) NAT/PAT We need to appear as one address. I creat...

How to configure PIX such that it redirect incoming http traffic to a internal proxy server?Thanks.

I have a Netscreen25 and a PIX 501 with an unusual setup. Here's how it looks.-Internet | Cisco 2600 Outside routable address | Inside address 10.0.0.1 | Netscreen Outside address Port 1 10.0.0.2 | Port 3 Inside address 192.168.1.1 | to 192.168.1.x |...