CLI command to find serial number on Firepower FPR9K-SM-24

[diana.contreras]

What is the CLI command to find the  FPR9k -Supervisor module serial numbers on firepower?
 

[balaji.bandi]

have you tried below commands  ?

show inventory 

show inventory expand detail

show serial-number

show serial

[diana.contreras]

Yes, had tried those but they did not work, see responses below:

HAU01-01A/corp# sho inventory
^
ERROR: % Invalid input detected at '^' marker.

HAU01-01A/corp# sho serial
^
ERROR: % Invalid input detected at '^' marker.

HAU01-01A/corp# sho serial-number
^
ERROR: % Invalid input detected at '^' marker.

[balaji.bandi]

FPR 9K - ok

Try

show server detail

[diana.contreras]

Working either:
HAU01-01A/corp# sho server detail
^
ERROR: % Invalid input detected at '^' mark

[balaji.bandi]

Do you have GUI access for the device ?

[garrison.sutton]

I think this is what you are looking for ...

FIREPOWER-A# terminal width 511

FIREPOWER-A# show server inventory
Server  Equipped PID Equipped VID Equipped Serial (SN) Slot Status      Ackd Memory (MB) Ackd Cores
------- ------------ ------------ -------------------- ---------------- ---------------- ----------
1/1     FPR4K-SM-12  V01          FLM220303UB          Equipped                    65536         12
FIREPOWER-A#

I had to start with the terminal command because the output wrapped around and was unreadable at first.

[diana.contreras]

The command does not work either: 

HAU01-01A/corporate# show server inventory
^
ERROR: % Invalid input detected at '^' marker

I am logged into the context on this. Looks like your command has you on the main context. 

Would I need to get to the main context before I run that command? 

How would I go to the main context? 

Thanks for your input.

[Abheesh Kumar]

Hi,

You login with the FTD management ip and tried this right...?

Login with FXOS management IP and issue command show server inventory to get the output.

To check the FPR sup inventory go to Connect Fxos  then type show module 1 to check the inventory.

HTH

Abheesh

[Muhammed Madappalli]

please use below command to get the serial number for chassis/SM/PSU/NM-Modules,

show chassis inventory expand

[wonderkleng1221]

Do scope chassis # first then type the show inventory command. 

# scope chassis 1

/chassis # show inventory expand detail

Hope that one will work for you.

[diana.contreras]

Hello, this command worked: 

N1-s2s-vpn# sho chassis detail
Chassis URL : https://website.:XX//
Chassis IP :      x.x.x.x
Chassis Serial Number : Jxxxxxxx

Thanks to all for your input. 

[bagus.putro1]

FPR4120-1# show server inventory
Server Equipped PID Equipped VID Equipped Serial (SN) Slot Status Ackd
Memory (MB) Ackd Cores
------- ------------ ------------ -------------------- ----------------
---------------- ----------
1/1 FPR4K-SM-24 V01 FxM220xxxxx Equipped
131072 24
FPR4120-1#

[willy-billy]

firepower-2110# show chassis inventory
Chassis    PID             Vendor            Serial (SN) HW Revision
---------- --------------- ----------------- ----------- -----------
1          FPR-2110        Cisco Systems, In XXXXXXXXX   1.3

[stevebiko]

Willy-billy, thanks. Worked even for FPR-1010