Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

Hello all, I have been working with a speed issue on an ASAv in a datacenter. I don't have access to the backend of the ASAv. We have a site to site VPN tunnel configured between the datacenter and the customer. We have been troubleshooting this for ...

johoss by Level 1
  • 845 Views
  • 6 replies
  • 0 Helpful votes

Hello everybody,our customer has a Firepower 2130 cluster running ASA OS rel. 9.14(3)18.I want to open a SSH session (Putty) to the outside IF that stay open for a daywithout further interactions.Unfortunately the session will be close after a couple...

swscco001 by Level 3
  • 1004 Views
  • 2 replies
  • 0 Helpful votes

 Hi, I have an audit that is picking up on the threat-detection CLI from an FTD show run and asking to change this:#threat-detection basic-threat to#threat-detection advanced-threatI obviously can't configure that within CLI and I don't see anywhere ...

Monadnock by Level 1
  • 1573 Views
  • 3 replies
  • 0 Helpful votes

Hi, I have configured remote storage backup on FMC 7.2.1, i configured it via SSH mode,  FMC backup is working fine as i see that FMC backup  file is getting created on remote server but FTD backup file do not see however i see FTD backup is getting ...

Anukalp S by Level 1
  • 1946 Views
  • 3 replies
  • 0 Helpful votes

on it we have SSL VPN access configured. This therefore enables the ability to ‘browse’ to the outside of the firewall.This in itself isn’t a problem, but what is a problem is that browsing to a random URL that is invalid sees the firewall redirect t...

Rock29 by Level 1
  • 1932 Views
  • 1 replies
  • 0 Helpful votes

I'm trying to setup communication between a few interfaces on a ASA 5508-X and can't seem to get ping to work.  Below is my configuration.  I have a laptop directly connected to "interface GigabitEthernet1/3" with a static IP of 192.168.20.3I can pin...

Dear All,I am running in to a problem and i cannot seem to wrap my head arround it.I have two servers in my network, i want to access the servers true RDP. What i want to do is the following.Service Management PortServer1RDP port: 3389Server2RDP port...

BdeBoer by Level 1
  • 1341 Views
  • 12 replies
  • 0 Helpful votes

Hello community, we are operating Cisco IPS sensors connected to FTD, however we noticed the category WEB-applications in the signature list it generates every month a lot of false positive alerts. I'm able to disable specific revision of signatures ...

rick11 by Level 1
  • 1451 Views
  • 2 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card