cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
7638
Views
10
Helpful
4
Replies

Command in cisco ASA to see security zones

thesikhkid
Level 1
Level 1

Hi there, 

 

A basic question.

I can't see security level and zone in show interface ip br command. 

Is there any command which can be helpful. 

 

Regards, 

Yad Singh

2 Accepted Solutions

Accepted Solutions

Collin Clark
VIP Alumni
VIP Alumni

Try 'show nameif'

ASA-FW# show nameif
Interface                Name                     Security
GigabitEthernet0/0       outside                    0
GigabitEthernet0/1       inside                   100
Management0/0            management               100

 

View solution in original post

Vibhor Amrodia
Cisco Employee
Cisco Employee

Hi,

You can try "show nameif"

Thanks and Regards,

Vibhor Amrodia

View solution in original post

4 Replies 4

Collin Clark
VIP Alumni
VIP Alumni

Try 'show nameif'

ASA-FW# show nameif
Interface                Name                     Security
GigabitEthernet0/0       outside                    0
GigabitEthernet0/1       inside                   100
Management0/0            management               100

 

thanks

Vibhor Amrodia
Cisco Employee
Cisco Employee

Hi,

You can try "show nameif"

Thanks and Regards,

Vibhor Amrodia

thanks bro

Review Cisco Networking for a $25 gift card