Configuration replication in pix 525

[arturo.reyna]

Hi:

I have two pix in failover.

Do I need type wr standby to replicate my configuration to the standby unit? or It is doing automaticaly when I type commands in the primary unit?

Thank you.

[scoclayton]

The easiest way is just to issue a 'wr mem' on the active PIX when you make any changes. Part of the function of the 'wr mem' is also to perform a 'wr standby' as well. So both PIX's are kept in sync should they be reloaded.

Hope this helps.

Scott