Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all:I have a 2851 as a MGCP Gateway and a CUCM and the deployment is working partially; because of duplicate subnet in two offices I teied to use NAT to reach IP phones from GW but it looks for real IP address.NAT is supported on VOIP solutions? W...
Hi, I have a 2851 with PVDM2-36DM but I wasn't able to work with them. It takes a long time the handshake, then a low speed connection and finally a disconection.I want to try with a modemcap for this kind of modem, or any other suggestion? My modem ...
Hi: I'm trying to setup a videoconference and I have a 2801 router (12.4(18c)) with NAT configuration between units but It doesn't work. I captured some packets with sniffer and I can see that units are trying to send voice and video information to t...
Hi everybody:I have two catalyst 6509 with supervisor engine redundandy; first one has the module 5 active and the second has the module 6 active.Is there a way to change configuration to set wich module will be active? I want to configure the same m...
Hi:I want to use a Catalyst 6506E in layer 3, I noticed that it has ipbase and I can not redistribute in EIGRP, It works as a stub. Could I use a diferent routing protocol as OSPF and then redistribute it in EIGRP?My network is EIGRP.Please let me kn...
BOT-RAS-PRUEBA#sh controllers e1 1/0E1 1/0 is up. Applique type is Channelized E1 - balanced No alarms detected. alarm-trigger is not set Framing is NO-CRC4, Line Code is HDB3, Clock Source is Internal. Module type is Channelized E1/T1 PRI Vers...
Jon:This is my config in 2801 router.ip nat pool P128-4 172.18.220.1 172.18.223.254 netmask 255.255.252.0ip nat pool epotor 172.18.251.230 172.18.251.230 netmask 255.255.255.0ip nat inside source list 19 pool P128-4ip nat inside source route-map epot...
