hi all i have configured the Cisco firewall with the following interface.
GigabitEthernet0/0
GigabitEthernet0/0.1 (Inside01) VLAN-1
GigabitEthernet0/1
GigabitEthernet0/1.1(Lan Based Failover) VLAN-110
GigabitEthernet0/1.2(Statefull Failover) VLAN-120
GigabitEthernet0/2
GigabitEthernet0/2.1(Outside01) VLAN-510
GigabitEthernet0/3
GigabitEthernet0/3.1(DMZ) VLAN-310
i have checked all the valid interfaces are having IP address and also are enabled state. I am trying to configure in Failover Mode.Active/Standby
I am missing some route because of which i am not able to communciation with the other network through any of the sub-interfaces. If i assign the IP to the physical interface everything works properly.
Any idea on where i am going wrong?
Vivek