Configure FTD 6.7.0 for site to site connection to remote FMC 7.0.1

[Cisco_OST]

I have a stand alone FTD that is remote with its only connection to the DC is via Site to Site VPN on the "outside" interface. I read where the version we are running supports using the data port as the management port, but I can not find any detail documentation on how to configure the FTD to support that function.

Thanks in advance.

[Francesco Molino]

Hi

 here is the documentation showing how to change the FMC access from management to data interface:

https://www.cisco.com/c/en/us/td/docs/security/firepower/misc/fmc-ftd-mgmt-nw/fmc-ftd-mgmt-nw.html#Cisco_Task.dita_0cbd837e-6a80-4e05-8734-7a73bcb2c850

if you have any question let me know. 

[Cisco_OST]

Thank you for your response, I have another question. What about on the FTD does that need to change as well?

[Francesco Molino]

If you change the interface used to connect the FTD with FMC, a change has to happen on the FTD as well.

The doc I shared is showing you all steps (including configuration).

Thanks 

[alirafaleiro]

This document describes how to configure a Route-based Site to Site VPN tunnel on a Firepower Threat Defense (FTD) managed by a Firepower Management Center (FMC).

https://www.cisco.com/c/en/us/support/docs/security-vpn/ipsec-negotiation-ike-protocols/216276-configure-route-based-site-to-site-vpn-t.html