03-28-2024 01:37 PM
Can anyone help me out with this. I've got Switches setup in ISE to use TACACS to authenticate the logins. I'm looking to setup DOT1X on the ports, along with MAB. I have the config in ISE set but i'm trying to determine exactly how to setup the swithes base raidius piece along with the switchports, without messing up TACACS. Am i overthinking this?
Solved! Go to Solution.
03-28-2024 03:07 PM
Hi @kyle311
I think you might benefit from looking into this article: 802.1X Switch Configuration Summarized
03-28-2024 01:46 PM
is it just:
radius-server host (ip addresse) key (key)
and then"
int gix/y/z
switchport mode access
switchport access vlan x
authentication port-control auto
dot1x pae authenticator
dot1x timeout tx-period 10
dot1x timeout uppp-timeout 10
?
03-28-2024 03:07 PM
Hi @kyle311
I think you might benefit from looking into this article: 802.1X Switch Configuration Summarized
03-29-2024 06:05 AM
Thank you much that was EXACTLY what I needed!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide