Hello, I have a 5510 and I'm trying to configure it, unfortunately Cisco thinks no one needs to use their firewall. So why am I trying to still use it? Well it's free and I'm using it as a project. A project thats been going on for years and really has been giving me hell from the start.
1. I'm working with the ASA and trying to get VPN set up. I don't know what is going on, but I believe it's ZeroSSL's fault. Following the videos and online forums were not helpful trying to set up VPN access. I don't have magic so I can't just make something that doesn’t want to work like they can. Again, I don't know if it work or not because ZeroSSL wasn't working when I was trying to verify my domain, many, many times.
So this is out.
2. Setting up the CA server locally also didn't work for me. Just do this, this and this and BAM, you’re done. Right? Nope. When I try to go to the page it told me to go (it's not a person so I have to guess). It's not loading, well why? I don't know, it's not being helpful and I could be typing 1 thing incorrectly and I would never know.
3. Routing, what needs to be done to route VPN traffic, local traffic, and whatever else? I can't get internet over the interfaces it's set up for. This **bleep** thing doesn’t want to work like it's supposed to.
Using GUI when I can, the most available form of configuration is in the CLI when remoting into a computer via Parallels.
Current hardware configuration is office ISP ASA and then office ISP to internal office resources.
Versions: ASA 9.1(7)39 ASDM 7.9(2)152
Hardware: ASA 5510 stock, SFP and (int 1/0-1/3) extra RJ-45 expandable slot
Just tell me where we should start then we can dive into it more.
If anyone would like to offer there smarts and help me, this would be greatly appreciated!!!
