Configuring VPN in Ciscoworks
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-01-2004 11:39 PM - edited 02-20-2020 11:43 PM
Hi
I am trying to add Cisco VPN Concentrator to Cisco Works . I am able to telnet to VPN from CW and also browse the device using CW but when I try to add the device using add device in RME , the device appears under not responding devices. When I attempt a connectivity test (management station to device test ) except for telnet and http all other protocol (including SNMPR)fails.
Vijay
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-05-2004 01:34 PM
What you need to do is to confirm if the device you are trying to add is supported by the version of RME you have. To do that, you could refer to the document at http://www.cisco.com/en/US/products/sw/cscowork/ps2073/products_device_support_tables_list.html
