10-19-2023 07:14 AM
I have two isp and one ASA5515 firewall and want to connect ASA5515 TO switch port 24 is there any configuration must be done to connect firewall to switch
10-19-2023 07:17 AM - edited 10-19-2023 07:50 AM
Check this how config subinterface in Asa.
Now for security if you use same security level for multi subinterface then you need
Same security permit intra-interface
Same security permit inter-interface
10-19-2023 07:45 AM
If the Switch Acting as Layer 2, you do not need to do any configuraton on the switch. (if you have only 1 Inside interface)
here is the ISP dual Failover blog:
10-19-2023 09:48 AM
Hello
if the fw interface is tagging (sub-interfaces) then the switch port will need to be a trunk otherwise it can just be a standard access port assign to a particular vlan
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide