Convert ASA v8.2 config to v9.4

[stownsend]

I'm moving from a ASA 5510 v8.2 to a ASA 5525-X v9.4  Short of putting in the 8.2 config in the 9.4 unit and picking up the Pieces, is there a preferred method to Migrate the config from 8.2 to 9.4?  I know the was Significant NAT changes.

Thanks!

[Vibhor Amrodia]

Hi,

You should follow this document to have a glance at the changes:-

http://www.cisco.com/c/en/us/td/docs/security/asa/asa83/upgrading/migrating.html

Also , check:-

1) Disable names on the ASA device

2) Disable no nat-control

Thanks and Regards,

Vibhor Amrodia

[stownsend]

Thank you for your Reply.

I was able to Upload a copy of the 8.2 config as startup, then rebooted. It came up with a couple issues, that I resolved in the 8.2 config, then copied it back to startup. I did that a few times until all of the Errors were taken care of, the only thing left was a Warning. Though This is Expected for my Remote VPN peers.

WARNING: For IKEv1, L2L tunnel-groups that have names which are not an IP
address may only be used if the tunnel authentication
method is Digital Certificates and/or The peer is 
configured to use Aggressive Mode
*** Output from config line 1163, "tunnel-group olivet.hayd..."

Thank you,

   Scott<-