05-12-2010 10:58 PM - edited 03-11-2019 10:44 AM
I read from the manual that the key pair will be used for SSH but just wonder does the command 'crypto key generate rsa' is necessary to enable SSH on ASA?
I can access to my firewall via SSH but when I checked in the configuration on ASA firewall by 'show run', I didn't see this command by the way. Anyone can guide me how to check if my ASA already be enabled 'crypto key generate rsa' ?
Thank you all very much for reply.
Solved! Go to Solution.
05-12-2010 11:14 PM
Yes, it is necessary to generate the rsa key pair for SSH access.
Here is the command to check the keypair in your ASA:
show crypto key mypubkey rsa
Hope that helps.
05-12-2010 11:14 PM
Yes, it is necessary to generate the rsa key pair for SSH access.
Here is the command to check the keypair in your ASA:
show crypto key mypubkey rsa
Hope that helps.
10-10-2017 06:01 PM
10-10-2017 07:28 PM
Have you tried the solution posted earlier in this thread?
10-10-2017 09:09 PM
Thanks @Marvin Rhoads for your reply.
I should have been more precise.
In fact, I am using IOSv and each time I stop & restart the device, I have to regenerate SSH keys for me to be able to connect through SSH.
Maybe, there is another way to generate SSH keys that persist the reload?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide