Network Security

Hello,I've configured a VPN from outside and it works fine. The problem I have is about the access to internet.The address pool to the VPN connection is not within the inside range. And I don't know which gateway I have to configure the VPN clients i...

Upon successfully connecting to Concentrator 3000, I realised, on the Ethernet adapter, that my ISP DNS entries were replaced and new WINS entries were added according to my DHCP server options 006 (DNS Servers) and 044 (WINS/NBNS Servers) respective...

I have a pix 515E with only two interfaces, an inside and an outside, but I need to connect two T1 internet connections on different subnets to the outside interface. I have a Cisco 3550 switch on the outside between the routers and the pix. I've bee...

I am setting up a Guest VLAN 25 to provide isolated access to the internet. It is not to have access to any internal networks. This VLAN is configured to give out DHCP addresses on a 192.168.25.0/24 subnet.The operational VLAN 1 is on 10.1.0.0/16. I ...

We have a PIX 515e with six interfaces. One interface is the DMZ with public addressing. One of the other interfaces is the inside which is using private addressing. The command below disables translation for the DMZ network because all servers are p...

Dear all,I am trying to configure a 'virtual' VLAN interface on the PIX.I have created the virtual interface off of our e0/2 interface (DMZ) and given it and IP address in the 192.168.100.X/24 range.I have also created a VLAN interface (VLAN 10) on t...

I am trying to configure VPN Concentrator 3000 DHCP to set Windows 2000 Pro "Connection-specific DNS Suffix" to "windows.ap.mycom.com".So far, "windows.ap.mycom.com" always goes to "DNS Suffix Search List" when I "ipconfig /all".Anyone knows what I a...

I am using PIX 515E. Internet connectivity is through satelite and is connected to the outside interface of the PIX. I wantto have a dial back up using normal Analog lines so that in case of satelite link failure pix can route the traffic through Dia...

Has anyone heard a time estimate for the release of pix software 7? I've heard it rumored for a long time now but it has gone silent recently. Any info would be appreciated.ryan

Can someone advise me on what would be the better solution for the following:A Hub and spoke network, new sites are going to be joining the main hub with PPP T1's, I still have to keep my network (main hub) protected and everyone else behind the PIX,...

I am trying to get a PIX running 6.3.3 to request a certificate from a Win2K server running certificate services. The server is running as a stand-alone root CA.The PIX config's for the CA access are:name 172.10.224.5 ca.lab1b972.comca identity ca.la...

In normal our PIX cpu usage is about 65%, but in this month the pix always have some problem. In one day continually appear up to 97% or the pix down.The ACL and anti ip snoop config has been added but useless.Dose any one have the same problem? And ...

currently have 6.3(1)any vulnerabilities?what's in 6.4(1)?should I upgrade?how much does it cost?

I have five cameras in the shop and all worked fine until I add the PIX 501 to the network. I put the static statements and ACLs in but when you go to the website and click on the camera feed you get the page can't be displayed. If i do a sh xlate I ...