Dynamic translation not working in ASA 8.0(5)

[Ramakrishnan G.]

I have a strange issue with my ASA which running with a code 8.0(5)

I've a simple NAT statement.

nat (monitoring-servers) 1 0.0.0.0 0.0.0.0

global (devices-cpe) 1 interface

which doesn't take effect. NATing is not happening when traffic traverse from interface monitoring-servers to devices-cpe. When I do packet capture it says    dynamic translation to pool 1 (No matching global). When I check "sh nat monitoring-servers" the destination interface devices-cpe is not showing in the command outpout

[Maykol Rojas]

Hello; 

It sounds like there is a NAT0 taking place or the route is pointing somewhere else. Can you paste the packet tracer output here? 

Mike. 

[Ramakrishnan G.]

Hello Maykol,

There is no NATO for this network to put under NAT-EXCEMPTION. Attached is the packet tracer ouput

If you look at the attachment. It is reading the NAT statement correctly on the phase 6 but it is unable to match the global command for this NAT id. ASA says no matching global but that's not the case,there is global statement.