Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

I have a customer using an ASA 5505 who we do very little work for so very often when they ask us to do some work it's something we've not touched before as in this case. I'm trying to setup VPN so the users can connect into the office network and I ...

Hi All, I have a IP SLA and track configured in ASA. I want to get a SNMP trap or a syslog alert when these go down. FW# sh sla monitor operational-state Entry number: 1Modification time: 22:07:31.216 CEST Tue Mar 15 2016Number of Octets Used by this...

Hi I am trying to setup a capture using type asp-drop to capture dropped traffic between a internal network and an external network and I need to monitor the drop for 24hrs. I am using the commands capture cap1 type asp-drop all match ip source subne...

Hi,   Please help me to understand how the acl works on asa code 9.x   If i want to block a host (172.16.10.250) from dmz  zone to outside (internet access ) and rest of the network should access .How can i do that ?   Which acl  from  below (1,2,3 &...

elite2010 by Level 6
  • 603 Views
  • 3 replies
  • 0 Helpful votes

hello guys, good morning !! i was trying to do password recovery in asa 5505. but i don't have image in my disk and i don't have tftp server even and even i tried to push reset button behind the firewall but it doesn't work.so you guys have any other...

mpate1311 by Community Member
  • 1922 Views
  • 9 replies
  • 0 Helpful votes

What is the maximum CRL size an ASA can support?  When configuring VPN for certificate authentication, I'd like to do CRL checking, but I've heard from another customer that they hit an issue with CRLs above a few MBs. Searching, the ONLY thing I've ...

colintulloch by Community Member
  • 1892 Views
  • 2 replies
  • 0 Helpful votes

Hi all, I have a 5525x and wanted to setup the FirePower that comes with the ASA. I have read and followed the Cisco installation guide, but I am unable to access the FirePower module on the ASA. What I have done; 1. Installed FireSight Mangement ---...

alex.vue by Community Member
  • 6227 Views
  • 6 replies
  • 0 Helpful votes
Top Solution Authors
Review Cisco Networking for a $25 gift card