02-06-2018 09:07 AM - edited 02-21-2020 07:17 AM
I'm trying to install a remote FMC1000-K9 appliance using the cli to configure it.
Launching the java-based KVM from the LOM connection (which was brought up with DHCP), I login as admin, and run:
sudo /usr/local/sf/bin/configure-network
then I answer the prompts about IPv4 address, mask, default gw, confirm them, decline to add IPv6 ... and it comes back with errors like these:
Updated network configuration.
Caught SFSystem Exception!
System (/sbin/ifconfig eth0) Failed -- (eth0: error fetching interface information: Device not found)
No settings for Management Interfaces speed at /usr/local/sf/lib/perl/5.10.1/SF/NetworkConf/NetworkSettings.pm line 2324.
Caught SFSystem Exception!
System (/sbin/ifconfig eth0) Failed -- (eth0: error fetching interface information: Device not found)
Updated comms. channel configuration.
Please go to https:/// to finish installation.
<hostname>:~$
Running ifconfig -a only shows me a lo interface, no eth0. Any suggestions on how to resolve this?
Solved! Go to Solution.
02-16-2018 08:23 AM
02-16-2018 08:23 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide