Failover Failed status

[foued kh]

Hi Team,

We have 2 ASA5515-x in failover Active/Standby mode. 
Recently, a failover has accured. I had this status :

Failover On 
Failover unit Secondary
Failover LAN Interface: FOLINK GigabitEthernet0/2 (up)
Unit Poll frequency 1 seconds, holdtime 15 seconds
Interface Poll frequency 5 seconds, holdtime 25 seconds
Interface Policy 1
Monitored Interfaces 3 of 114 maximum
MAC Address Move Notification Interval not set
Version: Ours 9.2(2)4, Mate 9.2(2)4
Last Failover at: 13:38:20 CEST Feb 6 2017
 This host: Secondary - Active 
 Active time: 2270284 (sec)
 slot 0: ASA5515 hw/sw rev (1.0/9.2(2)4) status (Up Sys)
 Interface INTERNET (x.x.x.x): Normal (Waiting)
 Interface LAN (x.x.x.x): Normal (Monitored)
 Interface WAN (x.x.x.x): Normal (Waiting)
 slot 1: SFR5515 hw/sw rev (N/A/5.3.1.6-16) status (Up/Up)
 ASA FirePOWER, 5.3.1.6-16, Up
 Other host: Primary - Failed 
 Active time: 0 (sec)
 slot 0: ASA5515 hw/sw rev (1.0/9.2(2)4) status (Up Sys)
 Interface INTERNET (0.0.0.0): Normal (Waiting)
 Interface LAN (x.x.x.x): Normal (Monitored)
 Interface WAN (x.x.x.x): No Link (Waiting)
 slot 1: SFR5515 hw/sw rev (N/A/5.3.1.6-16) status (Up/Up)
 ASA FirePOWER, 5.3.1.6-16, Up

What do you suggest for me, please to change the state of the second firewall from "Failed" status to "Standby" status.

Regards

[Marvin Rhoads · Accepted solution]

On the secondary firewall the WAN interface is down.

This condition is indicated in the following line:

Interface WAN (x.x.x.x): No Link (Waiting)

Fix the root cause for that and the unit should revert to "Standby" status.

[foued kh]

I am sorry for the delay Mr. Marvin.
Thank you so much for your advice.

[Marvin Rhoads]

You're welcome.

Please mark your question as answered if it has been.