Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Team,
I Have a site to site connect to another site of our office with encryption algorithm IKE Policy :
- Authentication : pre-share
- encryption : aes-192
- DH : 2
I have to add a new site to site connection to another site but this time, the...
Hi team,
I have to interconnect 2 sg550xg-24F in stack mode with 2 PA-220 in Active/Standby mode.
I choose this architecture :
I want to confirm with you if I must use VRRP in 2 switches and for the 2 Palo alto firewall should I need to use VRRP als...
HI all,
I have to install a vwlc in a network with many vlan ; vlan management , users , wifi , ..etc.I putted the controller vwmc in vlan management.What do you recommand for me , I assigned the access point to the same vlan of vwlc (vlan management...
Hi all,
I need to interconnect two 4500-x (in VSS mode) to two ASA 5500-x (in Failover Active/Standby mode).To establish this architecture, I think that :
- I need a L2 switch like 2960-x between the two VSS L3 Switches and the two ASA 5500-x Failov...
Thank you for your feedback Sir.I have resolved the problem by adding the two IKEv1 Policy, the CLI show command is as below :
crypto ikev1 policy 1 authentication pre-share encryption aes-192 hash sha group 2 lifetime 86400crypto ikev1 policy 2 auth...
Thank you for responding ,
In fact, I work with an ASA5515-x.The existing VPN STS is as below :
The IKE Policy credentiels are :
The second VPN STS that I have to add is as below :
Regards,
