FDM on FTD anyconnect change port and PBR

[dsfsd]

Hi. We have enabled FDM on our FTD sensor. On our effort to configure anyconnect, we cannot seem to be able to change the Anyconnect listening port from 443 to something else? Is this possible? Also i do not see any flexconfig on FDM, is there a way to achieve PBR?

[Bogdan Nita]

Not sure about  changing the port for anyconnect, but FDM does not support flexconfig.

HTH

Bogdan

[mveedock]

Hello,

Unfortunately, no.  As of Nov 2018 its not possible to change the default listening port within FDM from the default value of TCP 443.  The following enhancement was filed to get this feature added, so that AnyConnect can connect to a custom port:

CSCvi51189  ENH: FDM should allow custom non-UDP/TCP 443 port for webvpn/AnyConnect 

FDM lacks a lot of the features that are present in FMC.  So for this to work you'll need to move to FMC or wait for the enhancement to be completed.  Or you can fall back to the ASA platform which inherently allows the port change.

Mike Veedock

Cisco TAC